How to get water directly from plants

In tropical jungles, wild plantain can be seen everywhere. The core of this plant is full of moisture. As long as it is used from the bottom and quickly cut off, you will see clean The liquid drips out, and in the case of no food, the tender core of wild plantain can also be used to satisfy hunger. In addition, vines such as vines, schisandra vines, kudzu vines, and grape vines can also obtain drinking water through the above methods. Drinking water can also be obtained from cacti and their fruits. It should be noted that the sap of vines or shrubs and trees with emulsion is not drinkable and is poisonous.

Tips: The juice taken from the plant cannot be stored for a long time, it is easy to spoil, and you can drink it after taking it out. Of course, the above water intake method is limited to a small number of 3-5 people and short-term travel of 3-5 days, and is not suitable for too many people and long-term travel. The safest thing to do is to stay close to a water source, not to go into the jungle alone. If you find a source of water when you are extremely tired and thirsty, and you cannot drink it immediately, you must first take necessary purification and disinfection treatment of the water according to the environmental conditions at that time, so as to avoid poisoning or contracting diseases due to drinking water.

Reminder: The juice obtained from plants should be taken as soon as possible, because it is easy to spoil and cannot be stored for a long time. The above water intake method is suitable for situations where there are few people in the field and the number of travel days is small. If there are many people in the field and the time is relatively long, it is necessary to choose a place close to the water source, and be careful not to go into the jungle alone. If you find a water source, even if you are extremely tired and thirsty, try not to drink too much immediately. In order to avoid getting sick or poisoned by drinking water, you should carry out necessary disinfection and purification treatment of the water source according to the environmental conditions at that time.

Purification of drinking water in the wild

The water in the wild often contains some invisible pathogenic bacteria, such as amoeba dysentery, liver leech, typhoid, schistosomiasis, cholera etc., as well as rotting plant stems and leaves, insects, birds, animal corpses, feces, and some may also contain heavy metal salts or toxic minerals. Therefore, even if you find a source of water when you are extremely thirsty, you should not rush to binge drinking. You should carry out necessary purification and disinfection treatment on the water. In a very short period of time exhaustion of physical strength, serious, and even life-threatening.

Here are some simple and feasible methods for purifying and disinfecting water sources:

First, osmosis method

If there is floating in the water found When there are foreign objects or the water quality is turbid, you can dig a pit about half a meter deep and a diameter of about 1 meter at a distance of 3 or 4 meters from the water source, so that water can naturally seep out from the gaps of sand, stone and soil. Take out the oozing water and put it in a water storage container.

2. Filtration method

Use an empty Coke bottle, remove the bottom of the bottle, poke a few small holes in the bottle cap with a knife, and then fill the bottle with about 10cm of The soil is clean and fine sand, pour the water from the fine sand,

The filtered water will flow out from the bottle cap, and then use the container to catch the clean water. If you feel that the filtered water is not clean, you can Repeat filtering until clean.

3. When the altitude is lower than 3000 meters and there is fire, boiling the water for 5 minutes is also a good way to sterilize the water.

This article is provided by Xiaobian.