loading

Guide for Sewing inflatable Tent

2018-07-02

A: how to install the tent

1:To find  space , long , wide and high enough to place the tent on the ground .

2. Clean up the site, not allow have sharp objects and high-voltage wires to keep safety .

3. It would be much better if put a cushion under it such as carpets, plastic color cloth protect the tent from sundries .

4. Spread out and flatten the tent on the ground .

5. Connect the air inlet of inflatable tent and the outlet of blower tightly, and then tight alternative air inlet with a rope.

6. When the blower switched on, inflatable tent will be inflated within 10-30 minutes (depend the size of the tent ).

7. If there is a wind, fill the sandbag and tie it to D-rings on the bottom of the tent or tie the Stakes to D-rings on the bottom and insert the stakes in the soil .

 

B. Installation of Blower:

1. Check the voltage before use it and whether the blower revolves in a right direction.

2. There should be an earth wire and regular inspection. Protection net should be put on the air inlet of blower to avoid accidents.

 

C. Attentions:

1.In the event of strong wind (6 or more winds),heavy rainy, snowy, fogy, inflatable tent and blower are prohibited to use outdoor.

2. If the inflatable tent's pressure is too soft, check there if there are too many leaks and torn holes, or power failure. If pressure is too strong, please cover air inlet of blower a little.

 

D. Cleaning and Storage:

1. Cut off  the power, separate the blower and inflatable tent and open air outlet. It usually takes 10-15 minutes to let air out. The extra air must be squeezed out. If the device is watered, please dry it.

2. Do cleaning, use detergent to clean the stain, wipe away the grease, and cleaned with water, then dry it. Usually it can be cleaned by wet rags.

3. If do not use it for a long time, clean and pack it well. The best temperature to store is -50 ~ +40 degrees Celsius.

4. Blower should stay away from wet and corrosion. Inflatable tent should be protected from insects biting.

 

E. Maintenance

1. Clean the damage.

2. Pick up a piece of material from repair kit and cut 3 times as the damage in a circle shape.

3. Put some glue both on the damage and repair material.

4. Dry the glue totally and naturally (about 5 minutes). Then put them together and press them. The inflatable tent can be used again a few hours later.

5. If there is a large-scale non-normal damage, factory can provide professional maintenance services .


Chat Online 编辑模式下无法使用
Leave Your Message inputting...