Inflatable Projection Showing Wall Movie Screen For Outdoor Advertising

This is Inflatable fron projection movice screen we made for the Australia customer .

Inflatable movie screen is the best solution for a company requiring a professional grade projection surface, mobility, durability, and quick setup for the outdoor advertising. The dimensions of the inflatable showing walls are ccustomized, which can be used in the lawn and beach , everbody can enjoy a film happily !

We have two different workmanship inflatable movie screen , one is with airtight which only once inflate by the air pump . And another one is not airtight need the air blower inflate all the time during the work .

All kinds outside activities

1.For party event     2. wedding       3. As a store       4.exhibition      5.Advertising

                           

Elastic Rope

White color projection screen fix the black inflatable airtight frame with the elastic rope . So the surface is very smooth

                           

D anchor

Our inflatable progection movice screen is with a lot of D anchors for you tie down it on the ground .

                           

Airtight 

It is with weld workmanship so the inflatable flame is airtight only once inflate by the air pump .

heat welding machine : High precision heat welding machine and elaborated welding work for the inflatable movie screen .we can perfectly seal all the material pieces together into any reasonable inflatables, and heat weld all of our airtight inflatables with top quality standard with high efficiency

How to install  the inflatable movie screen?                                                                                                                                       

1.To find  space , long , wide and high enough to place the tent on the ground .
2.Clean up the site, not allow have sharp objects and high-voltage wires to keep safety .
3.It would be much better if put a cushion under it such as carpets, plastic color cloth protect the tent from sundries .
4.Spread out and flatten the tent on the ground .
5.Connect the air inlet of inflatable tent and the outlet of blower tightly, and then tight alternative air inlet with a rope.
6.When the blower switched on, inflatable tent will be inflated within 10-30 minutes (depend the size of the tent ).
7.If there is a wind, fill the sandbag and tie it to D-rings on the bottom of the tent or tie the Stakes to D-rings on the bottom and insert the stakes in the soil .

If you find a leak, you can wipe the air column first, then apply the surface with soapy water to check the leak. Leakage point If it is a small hole, you can use a small piece of circular maintenance cloth (any specifications of the inflatable tents inside the standard), and then brush dispensing, to be dry after the paste on the leak.
If the leak at the gas column heat seal at the opening of plastic, can be divided into the following steps:
1. First clean up the bonding surface.
2. Guangzhou Joy Inflatable Limited of the inflatable tents will be issued to the bottle of glue, inflatable tent column dedicated plastic, it will be painted on the pre-adhesive surface, must be painted evenly, the thickness of the appropriate brush map twice, you can Sticked up.
3. The shape of the mouth to be designed into a circular or oval, try to avoid the square and acute angle interface shape, lap width can not be less than 30mm.
4. To be glue after evaporation, can be bonded, patch to be flat, no wrinkles, rolling, scraping, while the supply of heat with the hair dryer, easy to bond. Adhesive after 6 hours can be inflated.

1、free design 

2、free repair kit and After-Sale service