bubble bath How to Make Tubs Non-Slip

Having a relaxing night at home and enjoying a comfortable bubble bath doesn't sound like a dangerous prospect, but our home may be more dangerous than we realize ---According to the Centers for Disease Control, about half of the falls occur at home.CDC reports that falls are not only the main cause of fatal injuries to adults over 65 years of age, but also the main cause of non-deathsFor all Americans, fatal injuries, including brain damage.When the tub is wet, our tub gets slippery and even the textured tub doesn't slide --proof.There are many easy ways to make your textured bathtub even lessslip.Wash the area with your regular bathroom cleaner.Rinse well.Dry the area thoroughly with a towel and wait 30 minutes to make sure the surface is completely dry.Check to make sure there is no lint or other debris on the surface of the tub.The epoxy coating spray is maintained at a distance of 12 to 15 inch from the surface of the bathtub, and the coating spray is covered throughout the area using a sweeping action.Wait 24 hours before using the bathtub.Re-apply every six to twelve months as required.Wash the area with your regular bathroom cleaner.Rinse well.Dry thoroughly with a towel.Wait 30 minutes to make sure the surface of the tub is completely dry.Check the area where you will apply the decoration to make sure there is no lint.Rub with your fingers in the area to check if there is any oil residue.Peel the paper on the back of the decal.Press the decal on the tub, start at one end and smooth it down with one side of your hand as you walk to avoid any wrinkles.Measure the bottom of the bathtub using a tape measure.Buy vinyl mesh shelf liner.Select rolls as wide or almost as wide as the bottom of the bathtub.Cut off the shelf liner of the right size with scissors to fit the bottom of the bathtub.Place the shelf lining at the bottom of the bathtub.In a gentle cycle, occasionally wash the liner in the washing machine.Measure the bottom of the bathtub using a tape measure.Buy a cushion that covers all or most of the bottom of the bathtub.Wash the bathtub using a normal bathroom cleaner and rinse it clean.When the tub is still wet, place the mat at the bottom of the tub with the suction cup down.Press firmly on the mat and hold it in place.Make sure you press the entire surface of the mat so you can engage all the suction cups.