toy tunnel inflatable bubble tent manufacturer for outdoor

                           

Bottom black zip

You can see the big dome is with bottom black zip for you put the bed ,furniture or some large object inside .

                           

Waterproof zip

Compare with the common zip , our zip is waterproof so you can use the inflatable bubble on the raining day .

                           

zipper with double sliders

Our zip is with double sliders you can zipper inside or outside .

heat welding machine : High precision heat welding machine and elaborated welding work for the bubble tent  .we can perfectly seal all the material pieces together into any reasonable inflatables, and heat weld all of our airtight inflatables with top quality standard with high efficiency.  We add reinforcement strips for the bubble tent so it have good airtightness and more durable .

Waterproof zip 

VS

not waterproof zip 

0.5MM PVC Transparent+0.6mm PVC 

VS

0.35mm PVC Transparent+0.45mm PVC

mosquito Net 

VS

without 

1.To find  space , long , wide and high enough to place the tent on the ground .
2.Clean up the site, not allow have sharp objects and high-voltage wires to keep safety .
3.It would be much better if put a cushion under it such as carpets, plastic color cloth protect the tent from sundries .
4.Spread out and flatten the tent on the ground .
5.Connect the air inlet of inflatable tent and the outlet of blower tightly, and then tight alternative air inlet with a rope.
6.When the blower switched on, inflatable tent will be inflated within 10-30 minutes (depend the size of the tent ).
7.If there is a wind, fill the sandbag and tie it to D-rings on the bottom of the tent or tie the Stakes to D-rings on the bottom and insert the stakes in the soil .

If you find a leak, you can wipe the air column first, then apply the surface with soapy water to check the leak. Leakage point If it is a small hole, you can use a small piece of circular maintenance cloth (any specifications of the inflatable tents inside the standard), and then brush dispensing, to be dry after the paste on the leak.
If the leak at the gas column heat seal at the opening of plastic, can be divided into the following steps:
1. First clean up the bonding surface.
2. Guangzhou Joy Inflatable Limited of the inflatable tents will be issued to the bottle of glue, inflatable tent column dedicated plastic, it will be painted on the pre-adhesive surface, must be painted evenly, the thickness of the appropriate brush map twice, you can Sticked up.
3. The shape of the mouth to be designed into a circular or oval, try to avoid the square and acute angle interface shape, lap width can not be less than 30mm.
4. To be glue after evaporation, can be bonded, patch to be flat, no wrinkles, rolling, scraping, while the supply of heat with the hair dryer, easy to bond. Adhesive after 6 hours can be inflated.

1、free to desige fee

2、free repair material and repair video