JOY inflatable inflatables for sale personalized for outdoor

Company Advantages
1. JOY inflatable custom inflatable arch is manufactured using quality raw materials and advanced production technology. Our products feature unique appearance
2. It can be designed with woven patterns which are often intricately detailed, allowing it to add a touch of color and decor to the room. Our products are waterproof and flame-retardant
3. Strict testing: its current performance has been tested by third parties. It is also ready to be tested by users and will be continuously updated. Our well-selected materials are good enough to satisfy the standards of EN71

All kinds outside activities

1.For party event     2. wedding       3. As a store       4.exhibition 

Technology : Sewing : we adopt special double needle strong thread sewing anywhere and quadruple stitching in positions sustaining much force and pressure for the inflatable arch  .

How to install  the inflatable arch?                                                                                                                                                            

1.To find  space , long , wide and high enough to place the tent on the ground .
2.Clean up the site, not allow have sharp objects and high-voltage wires to keep safety .
3.It would be much better if put a cushion under it such as carpets, plastic color cloth protect the tent from sundries .
4.Spread out and flatten the tent on the ground .
5.Connect the air inlet of inflatable tent and the outlet of blower tightly, and then tight alternative air inlet with a rope.
6.When the blower switched on, inflatable tent will be inflated within 10-30 minutes (depend the size of the tent ).
7.If there is a wind, fill the sandbag and tie it to D-rings on the bottom of the tent or tie the Stakes to D-rings on the bottom and insert the stakes in the soil .

If you find a leak, you can wipe the air column first, then apply the surface with soapy water to check the leak. Leakage point If it is a small hole, you can use a small piece of circular maintenance cloth (any specifications of the inflatable tents inside the standard), and then brush dispensing, to be dry after the paste on the leak.
If the leak at the gas column heat seal at the opening of plastic, can be divided into the following steps:
1. First clean up the bonding surface.
2. Guangzhou Joy Inflatable Limited of the inflatable tents will be issued to the bottle of glue, inflatable tent column dedicated plastic, it will be painted on the pre-adhesive surface, must be painted evenly, the thickness of the appropriate brush map twice, you can Sticked up.
3. The shape of the mouth to be designed into a circular or oval, try to avoid the square and acute angle interface shape, lap width can not be less than 30mm.
4. To be glue after evaporation, can be bonded, patch to be flat, no wrinkles, rolling, scraping, while the supply of heat with the hair dryer, easy to bond. Adhesive after 6 hours can be inflated.

1、free design 

2、free repair kit and After-Sale service 

Company Features
1. Equipped with advanced facilities, our factory reaches a high level of annual output.
2. That profession creates excellence is the belief JOY inflatable holds. Call now!