How to Measure the Projection of Knobs - where can i rent a mechanical bull

Cabinets and drawer knobs are not just decorative touches added at the last minute.
The size of the knobs will determine the effect of their use.
The width and projection of the knobs will help you decide if they are correct or not
Size accessories for cabinets or drawers.
The answer is not as simple as you think.
The knob sticks out from the surface to get you caught, which makes it easier to open the drawer or cabinet.
Drawers are also a decorative hardware.
Seamlessly integrate the knob with your decor.
With a variety of knobs, it's easy to find a knob that matches your space, but you need to make some measurements before you buy.
The width of the knob needs to be proportional to the surface of the mounting knob.
The raised part around the front boundary of the cabinet where the knob is located is stile.
The width of the knob should not exceed stile, because when a pair of cabinets are closed, the two knobs impact each other to prevent the cabinets from closing properly.
How far the knob extends also needs to be considered. In low-
Clearance space, knob away from the surface can be hit by passers-by.
They can also prevent when extra-
The long knob hits the wall.
The width of the knob will be the diameter of the round knob.
The knob that measures the widest part.
According to the book woodworking technology: the best way to make furniture with fine carpentry, most of the cabinet knobs set up in stile are located in the center of stile, 2 3/8 to 2 3/4 from the outer edge of the cabinet.
This means that in order to prevent the knob from hanging on the edge and hitting the knob of the adjacent cabinet in a double door, it should not exceed 4 2/3-to 5 1/4-inch wide.
When the knob is installed, the only part below the surface is the screw.
How far the knob in front of the door extends is measured from the butt of the knob material to the farthest tip.
This is suitable for drawers, cabinets and door handles.
For cabinets and drawer knobs, a screw may have been installed inside the knob and connected through the front of the drawer, but some of the knob's screws are inserted through a hole in the drawer into the back of the knob.
In both cases, the screw of the knob must be as long as the length of the knob and the sum of the width of the drawer or cabinet.