air bubble soccer How to Secure Electrical Wiring And Cables?

How to Insulating Electrical joints?Do you use color tape?Vinyl and plastic straps are cheap and easy to choose from.However, they are not as good as heat to shrink them.1.The tape is based on pressure sensitivity and adhesive.
They may not remain intact for a long time due to poor adhesive life.2.Vinyl and plastic straps do not have much resistance to chemical, wear and heat-related wear.Heat shrink tubes are safer due to chemical composition and mechanical reasons.
They can provide closeIt can be installed even on irregular splicing.Besides, they are not so confused.Let's see how the Heat Shrink tube works.First of all, you need a heat shrink tube of the right size.The heat shrink tube has different compression ratio.
However, although the most common compression ratio is 2:1, a 6:1 compression heat shrink tube is also used.The Standard Guide for choosing the right heat shrink tube is-after-The shrink diameter (recovery diameter) of the tube must be lower than the area diameter to be insulated or covered.In addition, the expansion diameter (before compression) must be large enough to fit the connectors and joints.
You have to cut the heat to the right length.Once heated, it also shrinks vertically up to 5 to 7%.So always try to keep an extra inch (about 1/4) at both ends ).
Slide the heat shrink of the cut in the area you want to cover.If you want to insulating the interwoven area of the cable, keep equal overlap on both sides for maximum protection.Now you need to heat the tube.You must know the temperature at which the tube shrinks.
Usually, we use a hot air gun to heat up.
You can also use iron welding, but no direct contact is allowed because this will burn out the shrink material.Manufacturers are never allowed to use open flames for shrinking purposes.To achieve a more suitable effect, you need to start heating from either end.
This will clear the bubbles inside the pipe (if any ).Slowly, rotate up or down on the pipe to move to the other end for the most effective fit.Keep heating until you get a comfortable fit.
Be careful not to overheat.
This will have an impact on the pipe material.Just reverse the process and you will get the heat shrinkage of the expansion diameter for easy disassembly